Set Date/Time - AT&T CL84100 User Manual

Telephone settings
Telephone base settings

Set date/time

The answering system announces the day and time of each message prior
to playing it. Before using the answering system, set the date and time as
follows. If you subscribe to caller ID service, the day, month and time are
set automatically with each incoming call. The year must be set so that the
day of the week can be calculated from the caller ID information. You can
turn off the date and time settings of the caller ID service and use your own
settings for each incoming call (see the Use caller ID to automatically set
date and time section on the following page).
After a power failure or handset deregistration, the system needs to reset the
date and time.
Follow the steps below to set the month, day, year and time on the
telephone base.
1. When the telephone base is in idle mode, press MENU/
main menu.
2. Press q/CID or p/DIR to scroll to >Settings, then
/SELECT.
press
MENU
3. Press q/CID or p/DIR to scroll to >Set date/time.
4. Press /SELECT twice to select >Date & time.
MENU
5. Press q/CID or p/DIR to choose the month then
/SELECT, or enter the number using the
press
MENU
dial pad keys.
6. Press q/CID or p/DIR to choose the day then
/SELECT, or enter the number using the
press
MENU
dial pad keys.
7. Press q/CID or p/DIR to choose the year then
press /SELECT, or enter the number using the
MENU
dial pad keys, then press
8. Press q/CID or p/DIR to choose the hour then
press /SELECT, or enter the number using the
MENU
dial pad keys.
9. Press q/CID or p/DIR to choose the minute then press
enter the number using the dial pad keys.
10. Press q/CID or p/DIR to choose AM or PM, then press
to confirm. There is a confirmation tone. Press CANCEL to cancel.
NOTE: If the clock is not set when a message is recorded, the system announces, "Time
and day not set," before it plays the message.
/SELECT to confirm.
MENU
27
to enter the
SELECT
Set date/time
>
Home area code
Date & time
>
CID time sync
SET DATE
--/--/--
SET TIME
--:-- --
/SELECT, or
MENU
/SELECT
MENU