Creating An Xrn Stacking Fabric; How To Interconnect Units; Switch 5500 Family - 3Com 5500-EI PWR Getting Started Manual

4
How To
Interconnect Units
C
REATING AN
F
ABRIC
This chapter contains the information you need to create an XRN
Stacking Fabric. It covers the following topics:

How To Interconnect Units

■
Guidelines For Interconnecting Units
■
Unit Numbering within the Fabric
■
The procedure for creating a Fabric with the Switch 5500-SI units is the
same procedure as that for creating a Fabric with the Switch 5500-EI
units.
Up to eight 3Com Switch 5500 units can be interconnected to create an
XRN Stacking Fabric and then treated as a single manageable unit with
one IP address.
You can interconnect your Switches to create an XRN Fabric using a
standard 1000 Mbps Ethernet connection.
variants of the Switch 5500 family, how they physically interconnect and
the level of XRN support offered by the Fabric.
It is not possible to create a Fabric by interconnecting a 3Com Switch
5500 with any other 3Com device or mix Enhanced Image (EI) Switch
5500 units with Standard Image (SI) units.
This section assumes you have either set up your units for management
as detailed in Chapter 3 "Setting Up for
using a console cable connected to the console port to set up and
allocate IP addresses and so on.
3Com recommends that you do not physically connect the cables on your
Fabric ports until you have carried out the initial configuration of the
Fabric ports as detailed below.
XRN S
TACKING
Table 14
Management"or that you are
lists the different