3Com 5500-EI PWR Getting Started Manual page 24

24 C 2: I
HAPTER NSTALLING THE
S
WITCH
Figure 4 Fitting a Bracket for Rack-Mounting
3 Insert the two screws and tighten with a suitable screwdriver.
You must use the screws supplied with the mounting brackets. Damage
caused to the unit by using incorrect screws invalidates your warranty.
4 Repeat steps 2 and 3 for the other side of the Switch.
5 Insert the Switch into the 19-inch rack and secure with suitable screws
(not provided). Ensure that ventilation holes are not obstructed.
6 Connect network cabling.
7 Finally place a unit information label on the unit in an easily accessible
position. The unit information label shows the following:
3Com product name of the Switch
■
3Com 3C number of the Switch
■
Unique MAC address (Ethernet address) of the Switch
■
Serial number of the Switch
■
You may need this information if you contact 3Com Technical Support.