Selecting A Source; Selecting The Computer Or Video Source - NEC NP-VE281 User Manual

Selecting a Source

Selecting the computer or video source

NOTE: Turn on the computer or video source equipment connected to the projector.
Selecting from Source List
Press and quickly release the SOURCE button on the projector cabinet to display
the Source list. Each time the SOURCE button is pressed, the input source will
change as follows: "COMPUTER", "VIDEO", "HDMI". To display the selected
source, press the ENTER button or allow 2 seconds to elapse.
Detecting the Signal Automatically
Press the SOURCE button once. The projector will search for the available input
source and display it. The input source will change as follows:
VE280X/VE280:
COMPUTER → VIDEO → COMPUTER → ...
VE281X/VE281/VE282X/VE282:
COMPUTER → VIDEO → HDMI → COMPUTER → ...
TIP: If no input signal is present, the input will be skipped.
Using the Remote Control
VE280X/VE280: Press any one of the COMPUTER1 and VIDEO buttons.
VE281X/VE281/VE282X/VE282: Press any one of the COMPUTER1, HDMI
and VIDEO buttons.
Selecting Default Source
You can set a source as the default source so that it will be displayed each time
the projector is turned on.
1. Press the MENU button.
The menu will be displayed.
2. Press the button twice to select [SETUP] and press the
the ENTER button to select [GENERAL].
3. Press the button four times to select [OPTIONS(2)].
4. Press the button five times to select [DEFAULT SOURCE SELECT] and
press the or button.
5. Select a source as the default source.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
The source you selected in step 5 will be projected.
TIP: When the projector is in Standby mode, applying a computer signal from a computer
connected to the COMPUTER IN input will power on the projector and simultaneously
project the computer's image.
[AUTO POWER ON(COMP.)](→ page 60)
3. Projecting an Image (Basic Operation)
button or
19
VE280X/VE280
VE281X/VE281/VE282X/VE282