Trouble Shooting - Haier HDY-C70 ME Operation Manual

Trouble shooting

The following must be confirmed before calling for service:
Problem
● Is the power supply plugged in and switched on.
● Plug another appliance into the wall socket to
test if there is power.
The dryer does not
● Check if a drying program has been set;
switch on
● the Start/Pause button has been pressed;
● The water collection box is full;
●Is the door closed tightly;
The dryer does not
switch on and the
●The loaded laundry has reached the requirements
screen displays "End"
for the drying setting.
●Is there a load in the drum.
●Have you selected the correct drying option;
●Has the filter screen been cleaned ;
●Is the condenser blocked;
● Does the amount of the loaded laundry
The drying result is
not up to standard exceed the rated load;
and the drying cycle
● Has the loaded laundry been spun dry;
takes too long.
●Is the vent duct blocked;
● Does the surface of the inside of the drum
have a deposit layer forming, if so clean the
drum interior;
The remaining time will be adjusted and corrected
continuously and automatically based on the
following factors:
The remaining time
●Type of laundry;
display is halted, or the
●Loaded amount;
remaining time displayed
●The moist degree of laundry;
is skipping
●Ambient temperature;
The automatic adjustment is a normal operation.
Possible Cause
Trouble shooting
Prompt and Alarm Information
In case of an improper operation or problem with the machine when it
operates, the code corresponding to the problem will be displayed on the
screen:
Cause
Code Category
There is no change in
Trouble code
E2
the temperatures of
the laundry in the tub
The thermal sensor
E5
Trouble code
open-circuited or short
circuited
Drain pump fails
Trouble code
E6
Solutions
Contact a professional
serviceman
Contact a professional
serviceman
Contact a professional
serviceman