Trouble Shooting - Haier HDY6-1 Operation Manual

Trouble shooting

Those listed below are not failures. The following must be confirmed before
calling for service:
Problem
Whether the power supply plug peels off;
Whether the local circuit is out of power;
Whether the door is closed tightly;
The dryer does
Whether a drying program has been set;
not start
Whether the Start/Pause button has been pressed;
Whether the condensate collection box is full;
Whether the drying program setting is correct or not;
Whether the filter screen has been cleaned up;
Whether the condenser is blocked;
The drying result is not
Whether the amount of the loaded laundry
good and the drying time
exceeds the rated load;
too long.
Whether the loaded laundry has been spun dry;
Whether the vent duct is blocked;
Whether the surface of the inside of the drum
gets a segregation layer;
Whether the power supply turns on;
The light in the drum is off
Whether the bulb is damaged;
The remaining time will be adjusted and corrected
continuously and automatically based on the
following factors:
The remaining time display
Type of laundry;
is halted, or the remaining
Loaded amount;
time displayed by skipping
The degree of spinning dry of laundry;
degression
Ambient temperature;
The automatic adjustment is a normal operation.
Possible Cause
Trouble shooting
Prompt and Alarm Information
In case of an improper operation or trouble with the machine when it operates, the
code corresponding to the trouble will be displayed on the display screen:
Cause
Code Category
Prompting the door
E1
Prompt code
not closed tightly
There is no change in
Trouble code
E2
the temperatures of
the laundry in the tub
E3
Trouble code
The laundry not dried
Prompting there is no
load or the loaded
E4
Prompt code
laundry has reached
the requirements for
the dry setting
E5
Trouble code The thermal sensor
open-circuited or short
circuited
Trouble code
Drain pump fails
E6
Note
: All information except for E1 needs to turn off the power and then
restart the machine to cancel the code.
Solutions
Shut the door closely and
restart the machine
Contact a professional
serviceman
Contact a professional
serviceman
Turn off the power and
reselect a program to
cancel the code
Contact a professional
serviceman
Contact a professional
serviceman