Advertisement
Available languages
Available languages
uirements
And Ma
l-:ollowing are important instructions
and infonnation
concerning
the exhaust requirements
tor your dryer.
Important
Warning::
To reduce the :risk of fire, combustion,
or accumulation
of combustible
gases, DO
NOT exhaust dryer air into an enclosed
and mwentilated
area, such as an attic, wall, ceiling, crawl space,
chimney, gas vent, or concealed space of a building.
"lb reduce the risk of fire, DO NOT' exhaust the dQcer with
plastic or thin foil ducting.
Use Only for Short Run
Installations
{6,35 cm)
0
65 feet (19.8 m)
45 feet (I3.7 m)
1
55 I)et (16.8 m)
35 feet (10.7 m)
2
47 feet (14.3 m)
30 feet (9.1 m)
3
36 feet (11.0 m)
25 feet (7.6 m)
4
28 feet (8.5 m)
20 t)et (6. I m)
0
1
2
3
4
55 fce_ (i 6.8 m)
47 fret (14.3 m)
41 fL'et (12.5 m)
30 feet (9.1 m)
22 feet (6.7 m)
35 l?eet (10.7 m)
27 feet (18.2m)
21 l_et (6.4 m)
17 feet (5.2 m)
15 feet (4.5m)
NOTE : Deduct 6 feet (1_8 m)for each additional elbow.
It is not recommended
to use more than 4 _° elbows.
Exhaust Requirements
and Instructions:
1. Vendng materials are not provided with the dwcr aud
you should obtain the necess_y venting materials
locally. For ex:ample, the outer end of exhaust pipe
must have a weaher hood with hinged dampe_ m
prewent back_drafl when the @er is not in use.
2. The exhaust
duct must be four inches (10.2 cm) in
diameter
with no obslrucfions.
The exhaust
duct
should be kept as shor! as possible.
Make sure to
clean any old ducts before instNling
your new dryer.
3. Rigid or semi-rigid
metal ducting is rc,conm_ended tor
u_ as transition ducth_g between the dryer and and fl_e
wal!. h_ s_ial
installations
when it is impossible
m
make a coimecdon
with the above
recommendations,
then a UL-lisled flexible metal transition duct may
u_d
betwee_ fl_e dryer and wall conneclion
only. The
u_ of this ducting will affect dry time.
4. DO NO]" u_ sheet metal screws on exhaust pi_ joints
or other thstening means which ex_end into the duct that
could catch lint and reduce the efficiency of the exlmust
system. Secure all joints with duct rope.
5. To maximize operating results, please observe the duct
length limitations noted in the chart above.
Advertisement
