Advertisement
Available languages
Available languages
irement For
¢
Review the following options to determine the appropriate electrical
connection for your home:
Use the instructions
in this section if your home has
a 4-wire :receptacle (NEMA tyl_e 14_30R) and you
will b.e using a UL misted, I20/240 volt mimmum,
30 amp_ duer F_)wer supply cord.
Use the instructions
in this section if your home has
a 3-wire receptacle (NEMA type 10-30R) and you
will be using a UI_ lismd, 120,/2da3volt mininmm,
30 amp, &yet _wer
supply cord.
If this type is available at your home. you will be
connecting
to a lused disconnect
or circuit breaker
box
If this tyw is available at your home. you will be
connecting
to a :fused disconnect
or circuit b:reaker
box
• Screw power supplywire to the terminal block.
Coloredwire should be connected to _me color
screw. Wire color indicatedon manual is
connected to the same color screw in block.
Otherwise, exce_ive cu_nt
is applied resulting
in damages on productand heating failure.
- Direct-wire connections do not m_
the
building code regulations in most areas. It is the
customer's responsibilit-ytoensure that the
installation meets all such requirements.
Important
: Grounding fhrough the neutral conductor
is prohibited tor (1) new branch-*circt|it installations, (2)
mobile homes, and (3) recreational vehicles, and (4)
areas where l_al codes prohibit grounding tls-ough tile
neutral conductor.
Prepare minimum 5fi (1.52m) of length in order tbr
duer to be replace_.
First, wee 5 inches (12.7cm) of coveting material from
eM. Strip 5 hlches of ground wire htsulation. After cutting
1_£ inch (3.8cm) front 3 olher wires peel insulatim| back
1hlch (2.5cm). Make ends of 3 wires a hook shape.
,¢
Then, put the hooked shatT_end of the wke under the
screw of the temlinal block (hooked end facing rightward)
and pinch tile hook together and screw tightly.
1. Connect neutral write (white) of _wer
cord m center
terminal block screw.
2. Comlect red and black wire to the left and right
terminal Nock screws.
3. Connect ground wire (green) of F_wer cord to
external ground screw and the move neutral ground
wire of a_ppliance and connect it to center scow.
4. M_:e sure that the strain relief screw is tightened.
and _ sure that all terminal Nock nuts are on tight
and power cord is in right _sitio_.
Advertisement
