Advertisement
Available languages
Available languages
Requirement
For E
Important
: Grounding dlrough the neutral conductor
is prohibited for (I) new branch,-circuit installations,
(2) mobile homes, and (3) recreational vehicles, and
(4) areas where local codes prohibit grounding |hmugh
the neutral conductor.
Prepare minimum 5ft (1.52m) of length in order for
dryer to be replaced.
First, strip 5 inches (12.7cm) of outer sheath from
end and strip 1 inch of insulation l}om each
conductor.
Then, put the hooked shape end of file wire under the
screw of die terminal block (hooked end facing
rig!ltward) aJld pinch the hook together and screw tightly.
1. Connect neutral wire (white) of power cord to
center mrminal bh_'k screw:
2. Connect red and black wire to the left and right
terminal Nock screws.
3. Make sure that the strain mlie:f screw is tighmned
and be sure that all terminM block nuts are on
tight and _r,_a_'r cord is in right Ix_sition.
Ceme*
t_mMal
b_k
screw(silver)
NeutraJ grounding
w_ (white)
N_v=_=r
al grounding
rare (w_.e)
[]
[]
Direct-wire connections
do not meet the
building code regulations
in most areas. It is
the customer's
responsibility
to ensure
that the
installation
meets
all such
requirements.
• It' your Iocal codes or ordinances do not allow the
use of a 3 wire connection,
or you are installing
your dryer in a mobile home, you must use a 4=
wire connection.
4-_re
r_tade
EMA type 14-30 R)
,.............. 4-pront plug
r _o- Spade t_inals
with
i
uptumea ends
g
Ring terminals
I.
2_
Connect neural
wire (white) of _)wer cord to
center terminal block screw.
Connect red and black wire to the lel_ and right
termi:nal block screws.
3. Connect ground wire (green) of power cord m
external ground screw and move neutral ground
wire of appliance mid connect it to center screw.
4. Make sure that tile strain relief screw is tightened
mid be sure that all terminal block nuts are on
tight and f-_)wer cord is in right position.
Advertisement
