Modifying Port Operating Characteristics - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

Modifying port operating characteristics

You can make permanent or temporary changes to port operating characteristics. The
set config port command makes permanent port configuration changes. These changes are saved in
the active configuration and are preserved across switch or port resets. The set port command makes
temporary changes that apply until the next port or switch reset, or until you activate a configuration.
IMPORTANT:
8-Gb/s SFP transceiver to 1-Gb/s will down the port.
The following example permanently changes port administrative state of port 1:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> config edit
8/20q FC Switch (admin-config) #> set config port 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
SymPortName
ALFairness
DeviceScanEnable (True / False)
ForceOfflineRSCN (True / False)
ARB_FF
InteropCredit
FANEnable
AutoPerfTuning
MSEnable
NoClose
IOStreamGuard
PDISCPingEnable
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
8/20q FC Switch (admin-config) #> config save
8/20q FC Switch (admin-config) #> config activate
You can configure all ports based on a specified source port using the set config ports command.
The set config ports command prompts you to configure the parameters of the source port, and then
applies those values to all of the ports. The following example configures all ports based on port 3:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) config edit
8/20q FC Switch (admin) #> set config ports 3
.
.
.
8/20q FC Switch (admin-config)#> config save
8/20q FC Switch (admin)#> config activate
8/20q FC Switch (admin)#> admin end
8 Gb/s SFPs do not support the 1 Gb/s setting. Setting a Fibre Channel port that has an
(1=Online, 2=Offline, 3=Diagnostics, 4=Down)
(1=1Gb/s, 2=2Gb/s, 4=4Gb/s, 8=8Gb/s, A=Auto) [Auto
(GL, G, F, FL, TR)
(string, max=32 chars)
(True / False)
(True / False)
(decimal value, 0-255)
(True / False)
(True / False)
(True / False)
(True / False)
(Enable / Disable / Auto)
(True / False)
1
8/20q Fibre Channel Switch command line interface guide
[Online] offline
]
[GL ]
[Port1 ]
[False ]
[True ]
[False ]
[False ]
[0 ]
[True ]
[True ]
[True ]
[False ]
[Auto ]
[True ]
65