One-step firmware installation
The firmware install and image install commands download the firmware image file from an
FTP or Trivial File Transfer Protocol (TFTP) server to the switch, unpack the image file, and perform a
disruptive activation all in one step. The one-step installation process prompts you to enter the following
information:
•
The file transfer protocol (FTP or TFTP)
•
IP address of the remote host
•
An account name and password on the remote host (FTP only)
•
Pathname for the firmware image file
To install the firmware:
1.
Enter the following commands to download the firmware from a remote host to the switch, install the
firmware, and then reset the switch to activate the firmware.
8/20q FC Switch #> admin start
8/20q FC Switch #> firmware install
The switch will be reset. This process will cause a
disruption to I/O traffic.
Continuing with this action will terminate all management
sessions,including any Telnet sessions. When the firmware
activation is complete, you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
2.
Enter your choice for the file transfer protocol with which to download the firmware image file. FTP
requires an user account and a password; TFTP does not.
FTP or TFTP
3.
Enter your account name on the remote host (FTP only) and the IP address of the remote host. When
prompted for the source file name, enter the path for the firmware image file.
User Account
IP Address
Source Filename : 8.0.00.11_epc
About to install image.
4.
When prompted to install the new firmware, enter y to continue or n to cancel. Entering y will disrupt
traffic. This is the last opportunity to cancel.
About to install image. Do you want to continue? [y/n] y
Connected to 10.20.20.200 (10.20.20.200).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
5.
Enter the password for your account name (FTP only).
331 Password required for johndoe.
Password:******
230 User johndoe logged in.
The firmware will now be downloaded from the remote host to the switch, installed, and activated.
: ftp
: johndoe
: 10.0.0.254
Do you want to continue? [y/n] y
8/20q Fibre Channel Switch command line interface guide
55