10Event Log Configuration; Starting And Stopping Event Logging - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

10 Event log configuration
This section describes the following tasks:
• Starting and stopping event
• Displaying the event
• Managing the event log
• Clearing the event
• Logging to a remote
• Creating and downloading a log
Event messages originate from the switch or from the management application in response to events that
occur in the fabric. For a complete listing of switch event messages, see the HP StorageWorks 8/20q Fibre
Channel Switch event messages reference guide.
Events are classified by the following severity levels:
• Alarm—The alarm level describes events that are disruptive to the administration or operation of a
fabric and require administrator intervention.
• Critical—The critical level describes events that are generally disruptive to the administration or
operation of the fabric, but require no action.
• Warning—The warning level describes events that are generally not disruptive to the administration or
operation of the fabric, but are more important than the informative level events.
• Informative—The informative level describes routine events associated with a normal fabric.

Starting and stopping event logging

To stop recording event messages in the switch log, enter the set log stop command in an Admin
session, as shown in the following example:
8/20q FC Switch (admin) #> set log stop
To start recording event messages in the switch log, enter the set log start command in an Admin
session, as shown in the following example:
8/20q FC Switch (admin) #> set log start
logging, page 105
log, page 106
configuration, page 107
log, page 108
host, page 108
file, page 109
8/20q Fibre Channel Switch command line interface guide 105