eMachines T3104 - 256 MB RAM User Manual page 63

CHAPTER 6: Networking Your Computer
56
In addition to a router, you need a straight-through cable for each computer
you want to connect to the network.
Router
To set up a network using a router:
Plug one end of the power adapter into the AC connector on the router
1
and the other end into a grounded, 110V electrical outlet.
Turn on your computers.
2
Plug one end of a straight-through network cable into any numbered port
3
on the router (except the WAN port). The WAN port is used to connect the
router to the DSL or cable modem, and is identified by a label or a switch.
Plug the other end of the cable into the network connector on the
computer. As each computer is connected to the router, the
corresponding green indicator should light on the front of the router,
indicating a good connection.
Repeat Step 3 for each computer on the network.
4
For an Internet connection, plug a straight-through cable into the WAN
5
port on the router and the other end into the Ethernet jack on the DSL or
cable modem.
Cable/DSL
modem
WAN port
www.emachines.com