eMachines T3104 - 256 MB RAM User Manual page 177

CHAPTER 13: Adding and Replacing Components
170
Disconnect the front I/O panel cables from the system board.
5
Remove the single screw that secures the front I/O panel to the case.
6
Rotate the I/O panel down until it faces the tabletop, then pull the I/O
7
panel and its cables away from the case. Note the location of the hole
through which the cables are threaded.
Thread the new I/O panel's cables through the hole in the case, then insert
8
the tabs in the bottom of the I/O panel into the slots in the front of the case.
Rotate the I/O panel up until its screw hole aligns with the screw hole in
9
the front of the case, then secure it to the case with the screw.
Reconnect the I/O panel's cables to the appropriate connectors on the
10
system board.
www.emachines.com
Screw