Installing A Processor Power Module - Compaq ProLiant CL380 User Manual

4-46 Compaq ProLiant CL380 User Guide

Installing a Processor Power Module

IMPORTANT: The Processor Power Module (PPM) is keyed to ensure correct alignment.
A notch in the bottom edge of the module, near the center, must align with a tab in the
mounting bracket. The notch and tab will not line up if the module is turned the wrong
way.
To install a PPM, perform the following steps:
1. Align the key slot in the bottom edge of the Processor Power Module
(PPM) with the tab in the PPM socket.
2. Insert the PPM straight into the PPM socket on the system board.


3. Press the module into the socket while pushing the latches inward until
they snap into place
2
Figure 4-49. Installing a PPM
4. Replace the server node in the system.
NOTE: For detailed instructions on replacing a server node, see the "Replacing a Server
Node" section earlier in this chapter.
5. Power on the server node and use the System Configuration Utility to
reconfigure your system.
.

1