Attaching The Slide Rail Assembly To The Rack - Compaq ProLiant CL380 User Manual

3-24 Compaq ProLiant CL380 User Guide

Attaching the Slide Rail Assembly to the Rack

3. Align the front screw holes in the slide rail and the mounting bracket.
4. Fasten the slide rail to the mounting bracket with three 8-32 x 1/4-inch
slotted screws . Retract the inner slide


hole that was covered when you attached the first three screws. Attach
the fourth screw

NOTE: Align the holes carefully. If the slide rail assembly is not lined up correctly, it will
not slide closed.
2
2
Figure 3-14. Attaching the slide rail to the mounting bracket
5. Repeat steps 1 through 4 for the other slide rail and mounting bracket.
Attaching the slide rail assembly to the rack consists of the following:
I
Marking the system's rack position with the template
I
Inserting cage nuts into the back of the rack
I
Installing the slide rail assembly on the rack

.
to access the fourth screw
1
1
3