Table of Contents
Advertisement
3. When the prompt <F1> Setup is displayed, press F1. If you have set an
4. Follow the instructions on the screen.
Setup utility menu
Use the Setup utility main menu to view and configure blade server configuration
data and settings.
The following menu items are on the Setup utility main menu. Depending on the
version of the Unified Extensible Firmware Interface (UEFI), some menu items
might differ slightly from these descriptions.
v System Information
v System Settings
22
BladeCenter HS22 Type 7870, 1936, and 1911: Problem Determination and Service Guide
Module Command-Line Interface Reference Guide, or IBM BladeCenter Serial over
LAN Setup Guide for information and instructions.
administrator password, you must type the administrator password to access
the full Setup-utility menu. If you do not type the administrator password, a
limited Setup-utility menu is available.
Select this choice to view information about the server. When you make changes
through other choices in the Setup utility, some of those changes are reflected in
the system information; you cannot change settings directly in the system
information. This choice is on the full Setup utility menu only.
– System Summary
Select this choice to view configuration information, including the ID, speed,
and cache size of the microprocessors, machine type and model of the server,
the serial number, the system UUID, and the amount of installed memory.
When you make configuration changes through other options in the Setup
utility, the changes are reflected in the system summary; you cannot change
settings directly in the system summary.
– Product Data
Select this choice to view the system-board identifier, the revision level or
issue date of the firmware, the integrated management module and
diagnostics code, and the version and date.
This choice is on the full UEFI Setup Utility menu only.
Select this choice to view or change the server component settings.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and
input/output (I/O) ports. You can configure the remote console redirection,
enable or disable integrated Ethernet controllers, and the SAS controller. If
you disable a device, it cannot be configured, and the operating system will
not be able to detect it (this is equivalent to disconnecting the device).
– Power
Select this choice to view or change power capping to control power
consumption and processor performance states.
Advertisement
Table of Contents
