IBM 7870B4U Service Manual page 169

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v See Chapter 4, "Parts listing," on page 41 to determine which components are customer replaceable units
(CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
Trained service technician.
Error code Description
0058008 DIMM failed memory test
0058009 All DIMM slots disabled. Slot 2 re-enabled,
no OS boot.
Action
1. Check the IBM support website for an applicable
retain tip or firmware update that applies to this
memory error.
2. Manually re-enable all affected DIMMs if the
server firmware version is older than UEFI v1.10.
If the server firmware version is UEFIv1.10 or
newer, disconnect and reconnect the server to the
power source and restart the server.
3. Install the affected DIMMs (as indicated by the
error LEDs on the system board or the event
logs) to a different memory channel or
microprocessor (see "Installing a memory
module" on page 65 for memory population
sequence).
4. If the error still occurs on the same DIMM,
replace the affected DIMM.
5. (Trained service technician only) If the problem
occurs on the same DIMM connector, check the
DIMM connector. If the connector is damaged,
replace the system-board assembly (see
"Removing the system-board assembly" on page
97 and "Installing the system-board assembly" on
page 98).
6. (Trained service technician only) Remove the
affected microprocessor and check the
microprocessor socket pins for any damaged
pins. If a damage is found, replace the
system-board assembly (see "Removing the
system-board assembly" on page 97 and
"Installing the system-board assembly" on page
98).
7. (Trained Service technician only) Replace the
affected microprocessor (See "Removing a
microprocessor and heat sink" on page 90 and
"Installing a microprocessor and heat sink" on
page 94).
1. If you disabled the DIMM, run the Setup utility
and enable the DIMM (see "Using the Setup
utility" on page 21).
2. Make sure that the DIMM is installed correctly
(see "Installing a memory module" on page 65
for more information).
3. Reseat the DIMM (see "Removing a memory
module" on page 64 and "Installing a memory
module" on page 65).
4. Replace the DIMM (see "Removing a memory
module" on page 64 and "Installing a memory
module" on page 65).
155
Chapter 6. Diagnostics