Installing Xfp Transceivers - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch User Manual

•
Local RS-232 serial console management interface
•
Remote telnet console management interface
See the HP 1:10Gb Ethernet Blade Switch for c-Class BladeSystem Browser-based Interface Reference
Guide for information on using the embedded HTML interface to manage the switch from anywhere on
the network using a standard browser, such as Netscape Navigator or Microsoft
See "SNMP MIBs support (on page 47)" for more information on the SNMP agents. This section also
describes how to use the MIBs to configure and monitor the switch using a generic SNMP manager, such
as HP OpenView Network Node Manager or HP Systems Insight Manager.

Installing XFP transceivers

CAUTION:
remove fiber-optic XFP transceivers with cables attached. Disconnect all cables from the XFP
transceiver before removing or installing an XFP transceiver.
CAUTION:
remove and insert XFP transceivers more often than is necessary.
CAUTION:
bare metal surface on the chassis to prevent electrostatic discharge.
CAUTION:
from the fiber-optic cable until you are ready to connect the cable. The plugs and caps protect
the XFP transceiver ports and cables from contamination and ambient light.
Remove the dust plug and save for future use.
1.
IMPORTANT:
Insert the XFP transceiver. With latch closed, be sure that the transceiver is fully seated and securely
2.
in place.
To prevent damage to the fiber optic cable or the XFP transceiver, do not install or
Removing and installing an XFP transceiver can shorten the useful life. Do not
HP recommends attaching an ESD-preventative wrist strap to your wrist and to a
Do not remove the dust plugs from the fiber-optic XFP transceiver or the rubber caps
Use only XFP transceivers purchased from HP.
® Internet Explorer.
Installing the switch 23