Replacing a switch
Replacing an existing switch
CAUTION:
communications between the server blade network ports that are connected through this switch
and the segment of network infrastructure those ports need to communicate.
For continued blade server network communication and services availability before removing
the switch, redirect critical high-availability services or applications to use the redundant
network ports available on those blade servers that are connected through the redundant
switch in the enclosure.
CAUTION:
To replace an existing switch:
Save the configuration file to a TFTP server for later retrieval. For more information on saving a
1.
configuration file to a TFTP server, see the HP 1:10Gb Ethernet BL-c Switch Command Reference
Guide.
Remove and label the cables.
2.
Remove the switch.
3.
Slide the new switch fully into the interconnect bay. For more installation information, see "Installing
4.
the switch (on page 21)."
Close the ejector lever and wait for the switch boot up completely.
5.
Removing the switch from a powered enclosure results in the loss of network
Do not cable the switch until after configuration.
Replacing a switch 25