Dell PowerConnect Zeiss 7048 Getting Started Manual page 18

Figure 1-11. Attaching the Brackets
2 Insert the supplied bolts into the rack-mounting holes and tighten with a
screwdriver.
3 Repeat the process for the rack-mounting bracket on the other side of the
switch.
4 Insert the switch into the 48.26 cm (19 inch) rack, ensuring that the rack-
mounting holes on the switch line up to the mounting holes in the rack.
5 Secure the switch to the rack with either the rack bolts or cage nuts and
cage-nut bolts with washers (depending on the kind of rack you have).
Fasten the bolts on bottom before fastening the bolts on top.
CAUTION:
rack.
NOTE:
Make sure that the ventilation holes are not obstructed.
16
Getting Started Guide
Make sure that the supplied rack bolts fit the pre-threaded holes in the