Install Vent Plug; Ul325 Entrapment Protection - Chamberlain LiftMaster Professional SL585 Installation Manual

Heavy duty slide gate operator heavy duty, harsh environment slide gate operator
Hide thumbs Also See for LiftMaster Professional SL585:
Table of Contents

Advertisement

INSTALL VENT PLUG

1. Disconnect power.
2. Remove the pin from the vented plug.
3. Reconnect power.
MODEL SL595

UL325 ENTRAPMENT PROTECTION

PRIMARY ENTRAPMENT PROTECTION ADJUSTMENTS
Force Control
Set the force control pot such that the unit will complete a full
cycle of gate travel but can be reversed off an obstruction without
applying an unreasonable amount of force. On most operators
this will be around the middle of the range.
SECONDARY ENTRAPMENT PROTECTION ADJUSTMENTS
Terminals 9 & 5 - Obstruction While Opening
(Edge/Photo Eye Input)
Edge Input: See Programming Section on page 15.
This input will reverse an opening gate to the close limit.
Activating this input when the gate is closing will have no effect.
NOTE: If upon reversal a second separate obstruction is detected
(gate edge or RPM sensor), gate will stop and alarm.
Photo Eye Input: See Programming Section on page 15.
This input will pause an opening gate. Once the input (photo eye)
is cleared, the gate continues to open. Activating this input when
the gate is closing will have no effect.
Terminals 10 & 5 - Obstruction While Closing
(Edge/Photo Eye Input)
Edge Input: See Programming Section on page 15.
This input will reverse a closing gate to the open limit. When
reaching the open limit the Timer-to-Close, if enabled, will be
disabled until another command is given. Activating this input
when the gate is closing will have no effect.
NOTE: If upon reversal a second separate obstruction is detected
(gate edge or RPM sensor), gate will stop and alarm.
Photo Eye Input: See Programming Section on page 15.
This input will reverse a closing gate to the open limit. This input
will not affect the Timer-to-Close. Activating this input when the
gate is closing will have no effect.
Pin
GL Board
14
MODEL SL585
Pin
Force Control
Obstruction While Opening
(Edge/Photo eye with N.O. Contact)
N.O.
Transformer
Electrical Box
Obstruction While Closing
(Edge/Photo eye with N.O. Contact)
N.O.
Max.
Min.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Liftmaster professional sl595

Table of Contents