Table of Contents
Advertisement
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Table 1-2. LED Descriptions (continued)
Object
Activity
Active LED
Off
(dual-WAN
On (Green)
port models
only)
Rear Panel
The rear panel of the UTM includes a cable lock receptacle, a console port, a reset button, and an
AC power connection.
Security lock
receptacle
Figure 1-3
Viewed from left to right, the rear panel contains the following components:
1. Cable security lock receptacle.
2. Console port. Port for connecting to an optional console terminal. The ports has a DB9 male
connector. The default baud rate is 9600 K. The pinouts are: (2) Tx, (3) Rx, (5) and (7) Gnd.
3. Factory default Reset button. Using a sharp object, press and hold this button for about eight
seconds until the front panel Test light flashes to reset the UTM to factory default settings. All
configuration settings are lost and the default password is restored.
4. AC power receptacle. Universal AC input (100-240 VAC, 50-60 Hz).
Bottom Panel With Product Label
The product label on the bottom of the UTM's enclosure displays factory default, regulatory
compliance, and other information (see
page
1-14).
1-12
Description
The WAN port is either not enabled or has no link to the Internet.
The WAN port has a valid Internet connection.
Console port
Figure 1-4
v1.0, January 2010
Reset button
and
Figure 1-5 on page 1-13
AC power
receptacle
and
Figure 1-6 on
Introduction
Advertisement
Table of Contents
Troubleshooting
