Toshiba MW27H63 Service And Owner's Manual page 66

2-2: CONFIRMATION AND ADJUSTMENT OF AUDIO/
CONTROL HEAD
When the Tape Running Mechanism does not work well,
adjust the following items.
1. Playback the VHS Alignment Tape (Monoscope of ST-N5
MODE2).
2. Confirm that the reflected picture of stamp mark is
appeared on the tape prior to P4 Cap as shown in Fig. 2-
2-A.
a) When the reflected picture is distorted, turn the screw
(1) clockwise until the distortion is disappeared.
b) When the reflected picture is not distorted, turn the
screw (1) counterclockwise until little distortion is
appeared, then adjust the a).
3. Turn the screw (2) to set the audio level to maximum.
4. Confirm that the bottom of the Audio/ Control Head and
the bottom of the tape is shown in Fig. 2-2-C.
c) When the height is not correct, turn the screw (3) to
adjust the height. Then, adjust the 1~3 again.
Audio/Control Head
Audio/Control Head
(5)
(3)
(2)
(4)
Audio/Control Head
Tape
MECHANICAL ADJUSTMENTS
Reflected picture of
Stamp Mark
P4 Cap
Stamp Mark
Fig. 2-2-A
[OK] [NG]
(1)
Fig. 2-2-B
0.25±0.05mm
Fig. 2-2-C
2-3: TAPE RUNNING ADJUSTMENT
(X VALUE ADJUSTMENT)
1. Confirm and adjust the height of the Reel Disk.
(Refer to item 1-1)
2. Confirm and adjust the position of the Tension Post.
(Refer to item 1-2)
3. Adjust the Guide Roller. (Refer to item 2-1)
4. Confirm and adjust the Audio/Control Head.
(Refer to item 2-2)
5. Connect CH-1 of the oscilloscope to TP1002, CH-2 to
TP4501 and CH-3 to HOT side of Audio Out Jack.
6. Playback the VHS Alignment Tape.
7. Press and hold the Digital Tracking button on the remote
control more than 2 seconds to set tracking to center.
8. Set the X Value adjustment driver (JG153) to the 4 of Fig.
2-2-B. Adjust X value so that the envelope waveform
output becomes maximum. Check if the relation between
Audio and Envelope waveform becomes (1) or (2) of
Fig. 2-3.
Envelope
(1)
CH-3
Audio
(2)
D2-3
Fig. 2-3