Service Mode List - Toshiba MW27H63 Service And Owner's Manual

This unit is provided with the following SERVICE MODES so you can repair, examine and adjust easily.
To enter to the SERVICE MODE function, press and hold both buttons simultaneously on the main unit and on the remote control
for more than the standard time in the appropriate condition. (See below chart.)
Set
Set Key
Condition
TV mode VOL. (-) MIN
TV mode VOL. (-) MIN
TV mode VOL. (-) MIN
VCR mode
VOL. (-) MIN
(Playback)
VCR mode
VOL. (-) MIN
(Playback)
VCR mode
VOL. (-) MIN
(Playback)
TV mode
VOL. (-) MIN
ALL mode VOL. (-) MIN
ALL mode
VOL. (-) MIN
DVD mode
REC/OTR
(No disc)
DVD mode
STOP(DVD)
(No disc)
DVD mode
REC/OTR
(No disc)
DVD mode
STOP(DVD)
(No disc)
Set
Set Key
Condition
ALL mode
VOL. (-) MIN
Method
Press the following remocon keys
continuously.
SETUP SUBTITLE
AUDIO SELECT 0

SERVICE MODE LIST

Remocon Standard
Key Time
0 2 sec.
1 2 sec.
2 2 sec.
3 2 sec.
4 2 sec.
5 2 sec.
6 2 sec.
8 2 sec.
9 2 sec.
0 2 sec.
1 3 sec.
4 2 sec.
7 2 sec.
Standard
Set Key
Time
FF 2 sec.
The disk cannot be taken out.
Refer to the "TRAY LOCK".
3
Releasing of V-CHIP PASSWORD.
Initialization of factory data.
NOTE: Do not use this for data normal servicing.
If you set factory initialization, the memories are reset such
as the clock setting, the channel setting, the POWER ON
total hours, and PLAY/REC total hours.
Horizontal position adjustment of OSD.
NOTE: Also can be adjusted by using the Adjustment MENU.
Refer to the "ELECTRICAL ADJUSTMENT" (OSD HORIZONTAL).
Adjust the PG SHIFTER automatically.
Refer to the "ELECTRICAL ADJUSTMENT" (PG SHIFTER).
Adjust the PG SHIFTER manually.
Refer to the "ELECTRICAL ADJUSTMENT" (PG SHIFTER).
Adjusting of the Tracking to the center position.
Can be checked of the INITIAL DATA of MEMORY IC.
Refer to the "WHEN REPLACING EEPROM (MEMORY) IC".
Check of the SUM DATA, POWER ON total hours, MICON VERSION
VERSION and DIGITAL TV MICON FIRMWARE on the screen.
Refer to the "WHEN REPLACING EEPROM(MEMORY) IC".
Display of the Adjustment MENU on the screen.
Refer to the "ELECTRICAL ADJUSTMENT" (On-Screen Display
Adjustment).
DVD Write mode.
Refer to the "RE-WRITE FOR DVD FIRMWARE".
NOTE: Do not use this for normal servicing.
Check for the firmware version.
Refer to the "RE-WRITE FOR DVD FIRMWARE".
NOTE: Do not use this for normal servicing.
Initialization of factory on DVD data.
NOTE: Do not use this for normal servicing.
Releasing of PARENTAL LOCK.
Refer to the "PARENTAL CONTROL - RATING LEVEL".
The BOT, EOT and the Reel Sensor do not work and the VCR deck
can be operated without a cassette tape.
Refer to the "PREPARATION FOR SERVING".
Operations
C2-1
Operations
Operations