Toshiba MW27H63 Service And Owner's Manual page 42

2-5: LOADING MOTOR/WORM (Refer to Fig. 2-5-A)
1. Remove the screw (1).
2. Remove the Loading Motor.
3. Remove the Worm.
Main Chassis
• Screw Torque: 3 ± 0.5kgf•cm
NOTE
1. In case of the Worm installation, check if the value of the
Fig. 2-5-B is correct.
2. In case of the Loading Motor installation, hook the wire on
the Cassette Opener as shown Fig. 2-5-C.
3. When installing the wires between Capstan DD Unit and
Loading Motor, connect them correctly as shown Fig. 2-5-D.
Safety surface for pressing
of the insert.
Pink
Loading Motor
-
+
White
DISASSEMBLY INSTRUCTIONS
Loading Motor
Worm
(1)
Fig. 2-5-A
19.2 ± 0.1mm
Fig. 2-5-B
Loading Motor
Cassette Opener
Fig. 2-5-C
Capstan DD Unit
L2
L1
Fig. 2-5-D
2-6: TENSION ASS'Y (Refer to Fig. 2-6-B)
1. Turn the Pinch Roller Cam clockwise so that the Tension
Holder hook is set to the position of Fig. 2-6-A to move the
Tension Arm Ass'y.
2. Remove the Tension Spring.
3. Unlock the 2 supports (1) and remove the Tension Band.
4. Unlock the support (2) and remove the Tension Arm Ass'y.
5. Unlock the support (3) and remove the Tension Connect.
6. Float the hook (4) and turn it clockwise then remove the
Tension Holder.
Tension Arm Ass'y
Tension Connect
Tension Spring
NOTE
1. In case of the Tension Band installation, note the direc-
tion of the installation. (Refer to Fig. 2-6-C)
2. In case of the Tension Band installation, install correctly
as Fig. 2-6-D.
3. In case of the Tension Connect installation, install as the
circled section of Fig. 2-6-E.
Tension Connect
B2-2
Fig. 2-6-A
(1)
(1)
Tension Band
(3)
Tension Arm Ass'y
Tension Holder
(2)
(4)
Fig. 2-6-B
Tension Band
Fig. 2-6-C