Toshiba MW27H63 Service And Owner's Manual page 49

Clamper Plate
Clamper
3-6: TRAVERSE HOLDER/INSULATOR (F)/INSULATOR
(R) (Refer to Fig. 3-6-A)
1. Remove the Traverse Holder.
2. Remove the 2 Insulator (F).
3. Remove the Insulator (R).
Main Chassis Ass'y
Insulator (F)
Traverse Holder
NOTE
1. In case of the Insulator (F) installation, install correctly
as Fig. 3-6-B.
2. In case of the Insulator (R) installation, install correctly
as Fig. 3-6-C.
Insulator (F)
Insulator (R)
3-7: SWITCH PCB ASS'Y/MIDDLE GEAR/FEED MOTOR
(Refer to Fig. 3-7-A)
1. Remove the screw (1).
2. Remove the Switch PCB Ass'y.
3. Unlock the support (2).
4. Remove the Middle Gear.
5. Remove the 2 screws (3).
6. Remove the Feed Motor.
7. Remove the Motor Gear.
DISASSEMBLY INSTRUCTIONS
No gap
Fig. 3-5-B
Insulator (R)
Insulator (F)
Fig. 3-6-A
Traverse Holder
Fig. 3-6-B
Main Chassis Ass'y (Top Side)
Fig. 3-6-C
Switch PCB Ass'y
Main Chassis Ass'y
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw (1))
• Screw Torque: 1.5 ± 0.3kgf•cm (Screw (3))
NOTE
1. In case of the Motor Gear installation, check if the value
of the Fig. 3-7-B is correct.
2. When installing the wire of the Switch PCB Ass'y, install
it correctly as Fig. 3-7-C.
3. After the assembly of the Main Chassis Ass'y, hook the
wire on the Main Chassis Ass'y as shown Fig. 3-7-D.
Motor Gear
Feed Motor
Safety surface for pressing
of the insert.
• Install wire from (1) to (4) in order.
~ FEED MOTOR ~
Main Chassis Ass'y (Bottom Side)
• Loosen the wire in the direction of the arrow.
B3-3
(1)
Middle Gear
(3)
(3)
(2)
Motor Gear
6.0 ± 0.2mm
~ SPINDLE MOTOR ~
YELLOW (2)
GREEN (1)
ORANGE (4)
BLUE (3)
Switch PCB Ass'y
Check Hook
Check Hook
Check Hook
Feed Motor
Fig. 3-7-A
Fig. 3-7-B
Fig. 3-7-C
Check Hook
Fig. 3-7-D