Installing The Heat Sink; Removing The Processor - Dell OptiPlex 9010 Owner's Manual

Installing The Heat Sink

1. Place the heat sink into the chassis.
2. Use a Phillips screwdriver to tighten the captive screws securing the heat sink to the system board.
3. Connect the heat sink cable to the system board.
4. Install the cover.
5. Follow the procedures in

Removing The Processor

1. Follow the procedures in
2. Remove the cover.
3. Remove the heat sink.
4. Press the release lever down and then move it outward to release it from the retention hook that secures it. Lift the
processor cover and remove the processor from its socket.
After Working Inside Your Computer .
Before Working Inside Your Computer .
25