Advertisement
Available languages
Available languages
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side.
If dishwasher is not level,
adjust front legs up or down until dishwasher is level.
Be sure rubber washer is properly seated in fitting. Slide the 3/4"
fitting up to the valve and hand tighten to avoid cross-threading.
Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional 1/4
to 1/2turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
Place paper towel under 90 ° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
If needed, see website for animated representation
of this step.
Visit www.whirlpool.com/watersupply
under FAQ tab.
NOTE: Do not use Teflon ®ttape with compression
fittings.
t®TEFLON
is a registered
trademark of E.I. Du Pont De Nemours and Company.
Place towel under drain hose to catch any water in drain hose.
Place the small green drain hose clamp onto the small end of the
drain hose. Push the new drain hose into the black drain hose
connector up to the drain hose stop.
Using pliers, squeeze open the small green drain hose clamp and
slide onto connector between stops.
Drain hose
Black drain hose
connector
--
Green clamp
After hose is connected, remove towel.
If needed, see website for animated representation
of this step.
Visit www.whirlpool.com/drain
under FAQ tab.
16
Advertisement
