Sync; Sdi Through; Input Signal Display - Panasonic TH-85PF12W Operating Instructions Manual

SET UP for Input Signals

SYNC

Select SIGNAL from the "SET UP" menu during RGB input signal.
Press to select the "SYNC".
Press to adjust.
Setting RGB sync signal
Confi rm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT signal).
AUTO: The H and V sync or synchronized signal are automatically selected.
If both input, it is selected the H and V sync.
ON G: Uses a synchronized signal on the Video G signal, which is input from
the G connector.
VBS: Uses a synchronized signal of Composite Sync input, which is input
from the HD connector.

SDI THROUGH

Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).
Note:
Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board (TY-FB11DHD)
is selected.
Press to select the "SDI THROUGH".
Press to select "ON" or "OFF".
ON:
OFF: Disables active through.

Input signal display

Displays the frequency and the type of the current input signal.
This display is valid only for COMPONENT/RGB/PC and Digital input signal.
Display range:
Horizontal 15 - 110 kHz
Vertical 48 - 120 Hz
The dot clock frequency is displayed during digital signal input.
54
Enables active through.
[ RGB ]
SIGNAL
SYNC AUTO
3 : 2 PULLDOWN OFF
XGA MODE AUTO
SYNC AUTO
SYNC ON G
SYNC VBS
[ Digital ]
SIGNAL
3 : 2 PULLDOWN OFF
SDI THROUGH OFF
REFRESH RATE 100 Hz
NOISE REDUCTION OFF
H-FREQ. 63.98 kHz
V-FREQ. 60.02 Hz
SIGNAL FORMAT 1280×1024/60
H-FREQ. 63.98 kHz
V-FREQ. 60.02 Hz
DOT CLOCK FREQ. 108.0 MHz
SIGNAL FORMAT 1280×1024/60