Sync; Sdi Through; Input Signal Display - Panasonic TH-65PF11WK Operating Instructions Manual

SYNC

Select SIGNAL from the "SET UP" menu during RGB input signal.
Press to select the "SYNC".
Press to adjust.
Setting RGB sync signal
Confi rm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT
signal).
AUTO: The H and V sync or synchronized signal are automatically selected.
If both input, it is selected the H and V sync.
ON G: Uses a synchronized signal on the Video G signal, which is input from
the G connector.
VBS: Uses a synchronized signal of Composite Sync input, which is input
from the HD connector.

SDI THROUGH

Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).
Note:
Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board (TY-FB11DHD)
is selected.
Press to select the "SDI THROUGH".
Press to select "ON" or "OFF".
ON:
OFF: Disables active through.

Input signal display

Displays the frequency and the type of the current input signal.
This display is valid only for COMPONENT/RGB/PC and Digital input signal.
Display range:
Horizontal 15 - 110 kHz
Vertical 48 - 120 Hz
The dot clock frequency is displayed during digital signal input.
Enables active through.
SET UP for Input Signals
SIGNAL
SYNC
3 : 2 PULLDOWN
XGA MODE
SYNC
SYNC
SYNC
SIGNAL
3 : 2 PULLDOWN
SDI THROUGH
REFRESH RATE
NOISE REDUCTION
H-FREQ.
V-FREQ.
SIGNAL FORMAT 1280×1024/60
H-FREQ.
V-FREQ.
DOT CLOCK FREQ.
SIGNAL FORMAT 1280×1024/60
[ RGB ]
AUTO
OFF
1024 × 768
AUTO
ON G
VBS
[ Digital ]
OFF
OFF
100 Hz
OFF
63.98 kHz
60.02 Hz
63.98 kHz
60.02 Hz
108.0 MHz
43