Changing The File Format - Sharp MX-M503U Quick Start Manual

CHANGING THE FILE FORMAT

The file format (file type and compression method) for sending a scanned image is specified when the destination
is stored in a one-touch key; however, you can change the format at the time of transmission.
The procedure for sending a scanned image in TIFF format is explained below.
The side to be scanned must be face up!
Scan
Auto
Mode Switch
Exposure
Image
Settings
200X200dpi
(1) Resolution
Send Settings
Auto A4
Special Modes
Original
Select a file format to apply it to
all scan destinations.
File Type
PDF TIFF
(4)
Encrypt PDF XPS
Programmed
Specified Pages per File
Address Book
Address Entry
PDF
File Format
Special Modes
(2)
File
Quick File
OK
(3)
Compression Mode OK
(6)
None
MH (G3)
MMR (G4)
(5)
(1-99)
1
Place the originals.
When using the document glass, place the
original with the side to be scanned face down.
2
Select format settings in the touch
panel.
(1) Touch the [Image Settings] key.
(2) Touch the [File Format] key.
(3) Read the displayed message and
touch the [OK] key.
(4) Touch the [TIFF] key.
(5) Touch the [MMR(G4)] key.
This sets the compression to high.
A higher compression ratio creates a
smaller file size.
(6) Touch the [OK] key.
3
Select the destination and press the
[START] key.
If the file type is set to [Encrypt PDF], you will be
prompted to enter a password when you start
transmission.
Cancel scanning
77