Table of Contents
Advertisement
Available languages
Available languages
USE THIS CONNECTIONN IF YOUR TV ONLY HAS A SINGLE ANTENNA IN JACK AND
DOES NOT HAVE ANY AUDIO/VIDEO JACKS. Please observe that you must adjust the TV to
the DVD-Recorder (channel 3 or 4).
Have the following cables ready:
an antenna cable (1, supplied), and a power cable (2, supplied).
1
Switch off your TV.
2
Remove the antenna or Cable TV signal from the antenna input
jack of the TV. Insert it into the ANTENNA IN jack at the back
of the DVD recorder.
3
Insert one end of the supplied antenna cable into the TV
OUT jack at the back of the DVD Recorder and the other end
into the antenna input jack at the back of the TV.
4
Connect the mains jack 4MAINS at the back of the DVD
Recorder with the power supply using the supplied power cable.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off. How you switch on this function again, read in the
chapter 'User preferences' in the section 'Standby'.
5
Press STANDBY-ON m on the recorder. '
appear on the display.
6
Switch on your TV and select the channel used for DVD/VCR
playback on your TV. Choose between channel 3 or 4.
The factory setting is for channel 3. However, if you would like to
switch to channel 4, proceed as follows:
Hold 4 on the remote control while '
1
2
'
' (channel 4) will appear on the display.
If you want to switch back to channel 3, hold 3 . '
3
will appear on the display.
7
Switch your TV to the selected channel (channel 3 or 4). Use
therefor your TV remote control.
The menu for language selection will appear on the screen.
' will
' is displayed.
' (channel 3)
Connecting the DVD Recorder
Advertisement
Table of Contents
