Philips DVDR615/37B Quick Install Manual

1
Remove the antenna or cable TV signal from your TV. Connect it
to the ANTENNA IN jack at the back of the DVD recorder.
2
Insert one end of the supplied antenna cable into the TV
OUT jack at the back of the DVD Recorder and the other end
into the antenna input jack at the back of the TV.
3
Use the supplied video (CVBS) cable and plug one end into the
yellow jack OUT VIDEO (CVBS) at the back of the DVD
Recorder and the other end into the Video In jack (usually
yellow) of the TV (usually called Video in or AV in. See your TV's
instruction manual).
4
Use the supplied audio (cinch) cable and plug one end into the
red/white cinch jack OUT L AUDIO R at the back of the DVD
Recorder (under to
corresponding red/white audio input jack of the TV (usually called
Audio in', 'AV in'. See your TV's instruction manual).
5
Switch on the TV. Then switch the TV to the Video/Audio input
jack or select the corresponding channel number. For the channel
number, please see your TV's instruction manual.
6
Connect the mains jack 4MAINS at the back of the DVD
Recorder with the power supply using the supplied power cable.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off.
7 Switch the DVD-recorder on using STANDBY-ON m .
' ' will appear on the display.
8
If necessary, select the channel number of the input socket at the
TV set.
The initial installation menu appears on the screen.
9
Select your preferred setting using CH- B or CH+ A .
Confirm with OK .
The initial installation is carried out automatically. Please wait until the procedure is completed.
Video in ) and the other into the
Initial Setup
Menu Language
English
Español
Français
Press OK to continue