Random Spots/Blurred Images; The Entire Output Is Blank - Epson AcuLaser C1750N User Manual

Random Spots/Blurred Images

Problem
The printed result has random spots or
is blurred.
Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.

The Entire Output Is Blank

If this trouble happens, contact the Epson local representative office or an authorised dealer.
Action
Ensure that the toner cartridges are installed correctly.
See also:
"Installing a Toner Cartridge" on page 204
If you use non-genuine brand toner cartridges, install genuine brand toner
cartridges.
Clean up the fusing unit.
1. Load one sheet of paper on the MPF, and then print a solid image all over paper.
2. Load the printed sheet with the side to be printed on facing down, and then print
a blank sheet of paper.
Epson AcuLaser C1750 Series
Troubleshooting
User's Guide
166