Epson AcuLaser C1750N User Manual page 140

Enter 5 in Mode 1 to put the printer in Mode 1 five minutes after it finishes a job. This uses less energy,
but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with
room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready
to operate with minimum warm-up time. Select a value between 5 and 30 minutes for Mode 1 if you
want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the Power Saver Mode when it receives
data from the computer. In Mode 1, you can also return the printer to the standby mode by pressing
any button on the operator panel. In Mode 2, you can return the printer to the standby mode by
pressing the (Energy Saver) button.
Fault Time-Out
Purpose:
To specify the time taken by the printer before it cancels jobs that stop abnormally. The print job is
cancelled if it times out.
Values:
Off
On
Time-Out
Purpose:
To specify the amount of time that the printer waits for data to arrive from the computer. The print job
is cancelled if it times out.
Values:
Off
On
Disables the fault time-out.
60sec.* Specifies the time taken by the printer before it cancels for jobs that
stop abnormally.
3–300sec.
Disables the job time-out.
30sec.* Specifies the amount of time that the printer waits for data to arrive
from the computer.
5–300sec.
Epson AcuLaser C1750 Series
Using the Operator Panel Menus
User's Guide
140