Installing The Shelf Supports - Electrolux EOD5410AAK User Manual

2
1

Installing the shelf supports

Install the shelf supports in the opposite se-
quence.
Valid with telescopic runners:
The retaining pins on the telescopic
shelf runners must point to the
front!
OVEN DOOR AND GLASS
PANELS
You can remove the oven door and the in-
ternal glass panels to clean them. The
Removing the door and the glass panels
A
B
2. Pull the rear end of the shelf support
away from the side wall and remove it.
number of glass panels is different for dif-
ferent models.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy.
1.
Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two
door hinges fully.
3. Close the oven door until the first posi-
tion (angle approx. 45°).
4.
Hold the oven door with one hand on
each side and pull it away from the
A
oven at an up angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
7. Pull the door trim to the front to re-
move it.
ENGLISH 23