Table of Contents
Advertisement
Power Management
To use communication software, you may have to disable power management. See
Disabling Power Management of Chapter 3.
LAN unit
5
You can connect to a LAN (Local Area Network) with the 100 Base-TX/10 Base-T
LAN unit on your computer. To activate the LAN unit, perform the following steps.
Connect the computer to LAN
1.
Turn off the computer.
2.
If your computer is provided with the LAN cable, go to Step 4. If with the core
for a LAN cable, go to the next step.
3.
Attach the provided core to one end of your LAN cable. Insert the cable into the
core and close the core until it clicks.
5-4
• See also the manual or online help of the software you are using.
• Within the communications software you are using, set the COM port
of the built-in modem to COM3.
• Do not enter System standby/hibernate while using communication
software.
• The communication speed may vary depending on the traffic, local
telecommunications infrastructure, and ISP (Internet Service Provider)
infrastructure.
• Before commencing with fax communication, it is recommended that
you exit other application programs.
Use a category 3 or a category 5 LAN cable when connecting to 10
BASE-T LAN, and the category 5 only when connecting to 100 BASE-TX
LAN.
Advertisement
Table of Contents
