Delay In System; Error Messages - Dynaudio pmn User Manual

Air_US_rev_111.qxd 16-12-2004
DELAY IN SYSTEM & ERROR MESSAGES ETC.
Sample Rate
(AES or WC In)
kHz
32.00
44.10
48.00
64.00
88.20
96.00
*): In Analog Input mode without WC Input selected, the system runs on the Master monitor's own 96kHz clock.
Error messages etc.
"!" as "96 kHz Center!"
The "!" indicates that the monitor is not connected to the
network. The volume is then automatically set to -50 dB for
the monitor not recognized.
"+" as "96 kHz L Front+":
The "+" indicates that the monitor you are looking at is the
System Controller.
>> A-Input Lo <<
This is displayed in analog setups only and indicates that
the Input level has been detected to be between -60dB and
-20dB for a period longer than 3 minutes. This is a hint to
turn up the Analog Input Gain
Analog Input gain range:
+9dBu, +15dBu, +21dBu or 27 dBu.
>> A-Input Hi <<
This is displayed in analog setups only and indicates that
an Input level near 0dB is detected. (peaks in 2 sec. above
-1 dB). This is a warning and you should turn down the
Analog Input gain range:
+9dBu, +15dBu, +21dBu or 27 dBu.
>> PSU error <<
Displayed if the power supplies fails. The power will be
turned off and the monitor cannot operate. Contact the
Service Department.
<Locked>
Displayed when a parameter is locked by the installer
software and cannot be changed.
Parameter lock can only be unlocked with AIR IP software.
56
14:18 Page 56
Digital Input
Converter Samples @
kHz Input Rate
93.00
64.00
68.00
88.20
40.00
96.00
34.00
64.00
34.00
88.20
34.00
96.00
msec centimeter Samples @
Converter Rate
2.91 100 73.00
1.54 53 73.00
0.83 29 73.00
0.53 18 73.00
0.39 13 73.00
0.35 12 73.00
Standby
Displayed when no Input signal has been detected for
more than 30 min. below -65 dB. The Amplifier is turned
off. Standby mode is released as soon a signal level above
-65dB has been detected.
>> Power save <<
Displayed when no signal has been detected on all
monitors on network for more than 2½ hours. Power is
turned off. Exit this mode by pressing any key on system
controller or adjusting volume from remote.
Analog Input *)
msec centimeter
1.14 39
0.83 28
0.76 26
1.14 39
0.83 28
0.76 26