When The Monitors Are Connected - Dynaudio pmn User Manual

Air_US_rev_111.qxd 16-12-2004
This is a simple step by step setup guide
Overview
1 Connect the monitors
2 Set one Master monitor as System Controller
3 Turn down volume
4 Set Bass Management off
5 Select Set up menu
6 Clear entire network
7 Select set up (Stereo analog, 5.1 digital, etc)
8 Select monitor tasks (e.g. "L Front","Center",
9 Set Clock Source
Connect the monitors
Power...
Audio...
Network...
Already at this point you must decide precisely what
type of setup you are going to use.
Connections must be done exactly according to the
Setups illustrated on pages 10 to 13.
Set one monitor as System Controller
One specific Master monitor in the setup must be
set as System Controller. This is done by leaving
out the TC Link button on the back of the monitor.
The Setup determines exactly which monitor this
must be. (see pages 10-13).
All other Master monitors must be set to operate as
"slaves" by leaving the TC LINK button in in-
position.
Turn down volume
Before going any further select first item in main
menu:
Volume
turn it down to: –50 dBFS (default setting on new
monitors)
– this is just to prevent bad surprises.
Set Bass Management
Next point in the main menu is:
Bass management
select:
Note: In Stereo setups with subs, the subs will only
play when Bass Management is set to "on".
14:16 Page 17

WHEN THE MONITORS ARE CONNECTED

Off
Go to Setup menu
Move to:
press:
Reset procedure
Select between following Reset options:
Reset all Settings
Hold ENTER when connecting Mains Power and
select "Reset all Settings"
A "factory" reset procedure that deletes all global
1
and local parameter settings as well as preset and
network settings.
Clear entire network:
Select "Clear Entire Network" and press ENTER in
the Setup menu.
Select Setup
Now you must define which kind of set up you
have:
2
Empty
Custom
Stereo analog
Stereo digital
5.1 analog
5.1 digital
6.1 analog
6.1 digital
5.3 analog
5.3 digital
5.1 digital/6 Master
3 etc. etc.
Select monitor tasks
Now select first monitor and press ENTER
Pink Noise is generated in one of the monitors:
Set monitor tasks
(Pick matching task for the position of the monitor
where Pink Noise appears. E.g. "Master L front",
press:
4
External Source
BNC Input On:
The monitor attempts to lock on the Word Clock
BNC connection.
BNC Input Off:
The monitor will attempt to lock on the AES Input.
Setup menu
ENTER
Exit
5
6
7
8
9
17