Parameter Description - Dynaudio pmn User Manual

Dynaudio loudspeaker user's manual

Hide thumbs

Table Of Contents

Table of Contents

Air_US_rev_111.qxd

16-12-2004

Basic operation in all menus

• Use ARROW keys to select value or submenu

• Use ENTER to enter menus or for confirmation, and to

activate

• Use EXIT to step to a higher level or to decline an

operation

• Values are marked with an " * " when they can be altered

via the ARROW keys

Main Display

The Main Display indicates the position of the monitor

(when set up) and the set volume for the monitor.

A "+" indicates that this specific Master Unit has been set

up to act as System Controller.

Bass Management

Bass management is possible in:

- Standard Stereo with 1 Sub

- Standard Stereo with 2 Subs

- 5.1 Analog

- 5.3 Analog

- 6.1 Analog

- 6.1 Digital - at 192kHz

- 5.3 Digital

- 5.1 Digital/6 Master

- 5.1 Digital - at 192kHz

Satellite monitors uses 2'nd order Hi Pass filters to

attenuate frequencies below the set Cross-over frequency.

Subs use 4th order Low Pass filter to attenuate frequencies

above the set Cross-over frequency.

• Press ENTER to access the Select Mode

Off:

Bass Management is not activated. Only the LFE channel

is distributed to the Sub.

PCIP

Via Air PCIP (optional software for the advanced installer)

and advanced Bass Management mode is available. In this

mode all filters (Satellite, Sub4 and Sub2) can be controlled

to suit demanding setups.

Cross-over frequencies:

Menu Name

X-Over 50 Hz

X-Over 80 Hz

Extension 50 Hz

Extension 80 Hz

THX Sim 80 Hz

Small Cons 120 Hz *

Note that the Extension 50 and 80Hz uses no Bass Management on satellite speaker thus playing full range.

* Small Cons - Small Consumer

14:16

Page 18