Setups - Dynaudio pmn User Manual

Air_US_rev_111.qxd 16-12-2004
To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
10
14:15 Page 10

SETUPS

Stereo Setup
This illustration shows how to connect a standard
stereo setup.
• Left monitor is set as System Controller by leaving out
the TC Link button on the rear panel.
• Left monitor receives both Left and Right Input signal.
• Right monitor receives audio via the TC-LINK RJ-45
connection.
• The Remote and/or AIR Soft, can be connected to any
available TC LINK Out connection.
Stereo Setup with mono Sub(s)
This illustration shows how to connect a stereo setup
with 1 Sub.
• Left monitor is set as System Controller by leaving out
the TC Link button on the rear panel.
• Left monitor receives both Left and Right Input signal.
• Right monitor and Sub receives audio via the
TC LINK RJ-45 connections on the Left monitor.
• With no Bass-management, no signal is sent to the Sub.
• With Bass-management activated, Low Frequency
information from Left and Right channels below the set
Cross-over frequency is extracted and fed to the Sub.
• The Remote and/or AIR Soft, can be connected to any
available TC LINK Out connection.
Stereo Setup with stereo Subs
This illustration shows how to connect a stereo setup
with SUBs.
• Left monitor is set as System Controller by leaving out
the TC Link button on the rear panel.
• Left monitor receives both Left and Right Input signal.
• Right Monitor and Subs receive audio via the TC LINK
RJ-45 connection as illustrated.
• With no Bass-management, no signal is sent to the Sub.
• With Bass-management activated, Low Frequency
information from Left and Right channels, below the set
Cross-over frequency, is extracted. Low frequency
information from the Left channel is distributed to L Sub
and Low Frequency information from the Right channel is
distributed to the Right Sub.
• The Remote and/or AIR Soft, can be connected to any
available TC LINK Out connection.