Step1: Ask Mobilemapper Ce To Be Paired With The Cell Phone - Magellan MobileMapper CE - Hiking GPS Receiver Getting Started Manual

20
Step1: Ask MobileMapper CE to Be Paired with
the Cell Phone
Start Bluetooth Manager
1. On MobileMapper CE, tap
then double-tap the Bluetooth Manager icon. The Bluetooth
window appears on the screen after a few seconds.
Note the presence of the
quick overview of the Bluetooth Manager toolbar, please
refer to Bluetooth Manager Toolbar Memo on page 65. For
more details about Bluetooth Manager, please refer to
Bluetooth Manager Module on page 49
Detect the Cell Phone
Caution!
MobileMapper CE and the cell phone should not be
too close to each other. Keep a minimum distance of 60 cm
(2 feet) between the two devices.
1. Turn on your cell phone.
2. Activate its Bluetooth device. Refer to the instructions
manual of your cell phone to do this.
3. Make its local Bluetooth device discoverable from external
Bluetooth devices such as MobileMapper CE. Again, refer
to the instructions manual of your cell phone to do this.
4. On MobileMapper CE, tap
tooth-enabled devices present in the vicinity, including
your cell phone.
At the end of this sequence, the icon representing your
cell phone should be visible in the Bluetooth Manager
window (see example opposite). Other Bluetooth devices
may have been detected during this search sequence.
,
NOTE: Tap
resume the search sequence.
>Settings>Control Panel and
icon in the task bar. For a
to search for the Blue-
not , if for any reason you need to