Local Services; Introduction - Magellan MobileMapper CE - Hiking GPS Receiver Getting Started Manual

52
- To demand that a remote device be allowed to access the
local services only after pairing itself with MobileMapper
CE, check the Enabled box underneath Authentication. Oth-
erwise keep this option disabled (check box cleared).
Caution!
This option is automatically disabled every time
you start Bluetooth Manager.
- Tap OK on top of the window for the changes to take
effect.

Local Services

Introduction

The local services offered by MobileMapper CE's Bluetooth
controller are the following:
• Serial Port Service. The Serial Port service allows you to
exchange data with a remote device via a virtual Bluetooth
serial port. This service is used when outputting GPS data
via an auxiliary output (see GPS Ports Configuration on
page 44).
• File Transfer Service. This service allows any two Blue-
tooth-enabled devices to exchange files.
• Object Push Service. This service is required to run the
File Transfer Service but is not usable as such in MobileM-
apper CE.
To list the local services offered by MobileMapper CE:
• Tap located in the Bluetooth Manager toolbar. The
Bluetooth window shows the three icons representing its
three local services.
Note that all the services are made active at power up (a
small green circle containing a plug symbol is visible on
each of the icons; see screen opposite).