Table of Contents
Advertisement
Setup Mode Functions
The Setup mode includes nine (9) functions. To enter the Setup mode, press and
hold the SET button until you hear a beep. The LCD will then display SETUP.
Press the SET button to scroll through the available functions. To exit the Setup
mode, press and hold the SET button until you hear a beep. Each function is
explained below.
Automatic
This function is for factory use only.
Partition Name
The
Partition Name
the hard disk drive.
The first two (2) digits are the ID number of the hard disk drive. This ID can range
from 00 to 99. The remaining three (3) digits represent the position of the partition.
The default setting is 00000.
Set as Default
This function allows you to set any changes or modification you have made as
your default settings.
Update Firmware
The
Update Firmware
CD or DVD disc. The DVD Duplicator will locate the data and update its
firmware automatically.
During the update, do not turn off the power to the unit. Once the update is
complete, the LCD will display a message and all arguments will return to the
default setting. Please restart the system to complete the firmware update
procedure.
CD Reading Speed
The
CD Reading Speed
reads a CD-ROM.
The default setting is
❑ RUN: Modify parameter.
❑ SET: Save and quit.
TEAC 1x10 DVD Duplicator User's Manual
function enables you to setup the ID and partition number of
function updates the firmware on the interface board via a
function controls the speed at which the source drive
(maximum) read speed.
MX
Setup Mode Functions
13
Advertisement
Table of Contents
