Table of Contents
Advertisement
Chapter 3. DVD Duplicator Functions
The DVD Duplicator features three (3) modes of operation:
❑
mode
Operation
❑
mode
Setup
❑
mode
Advanced
Operation Mode Functions
mode includes seven (7) functions. Each function is explained below.
Operation
Test
The
function simulates writing to the target disc. The discs will remain blank
Test
after the test is complete. This function is recommended if you are using
unsupported media. This function enables the target drive to adjust the laser to the
proper intensity. The source drive, which is determined by the setting on the
Duplicator controller, can be either the DVD-ROM drive or the hard disk drive.
Copy
The
function enables you to copy data from the source DVD or a partition
Copy
on the internal hard disk drive. For more information, refer to "Basic Operation"
on page 8.
Compare
The
function compares data on the source and target discs after the copy
Compare
process is complete.
Copy and Compare
The
function follows immediately as soon as the
Compare
completed.
Verify
The
function verifies that the target disc was written completely and with
Verify
no errors.
TEAC 1x10 DVD Duplicator User's Manual
Operation Mode Functions
function is
Copy
11
Advertisement
Table of Contents
