Self Help - Bosch SGE63E06UC - Evolution 24" Special Application Dishwasher FR Operating Instructions Manual

Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The following information may help you
with a dishwasher problem without involving a repair professional.
Problem Cause
Dishwasher 1. Door may not be properly latched.
does not start 2. Unit may not be turned on.
3. Unit not reset or previous cycle not completed.
4. Delay start engaged.
5. Interruption of electrical power supply to dishwash-
er or blown fuse.
6. Child lock activated (select models).
7. The door may have been closed without first select-
ing a cycle.
8. Water supply may not be turned on.
Dishwasher Default factory settings alert the customer that the cycle
beeping (end
has completed by beeping. This feature can be deacti-
of cycle signal)
vated if so desired.
Display does 1. A fuse may have been blown or circuit breaker
not illuminate tripped.
or console 2. Door not closed or latched.
lights are not Note: For models with controls on the top portion of the
on door, the display only illuminates when the door is opened and
controls are visible.
Dishwasher 1. Incoming water is not warm enough.
seems to run a 2. Cycle time can vary due to soil and water condi-
long time tions.
3. Rinse agent dispenser is empty.
4. Dishwasher connected to cold water supply.
Note: Refer to "Cycle Chart Data" section in this manual
for typical cycle length.
Dishes aren't 1. Spray arm movement is obstructed.
getting clean 2. Spray arm nozzles clogged.
enough 3. Improper use of detergents.
4. Filters could be clogged.
5. Dishes are nested or loaded too close together.
6. Selected wash cycle is not suitable for food soil
condtions.
Dishes are not 1. Rinse agent dispenser is empty. (Rinse agent indica-
getting dry tor is activated).
enough 2. Improper loading of dishes.
3. Selected cycle does not include drying.
Note: Plastic or Teflon do not typically dry as completely
as other items due to their inherent properties.
Odor 1. Food debris is present at the bottom of the dish-
washer.
2. Food particles are present near the door seal.
3. Dishes left too long in unit before running a cycle.
4. Residual water is present at the bottom of the dish-
washer.
5. Drain hose is obstructed.
SELF HELP
Action
1. Shut the door completely.
2. Press the main power switch to turn unit on.
3. To reset, refer to "Canceling or changing the cycle" section in this
manual.
4. To reset, refer to "Delay Start" section in this manual.
5. Check circuit breaker.
6. Deactivate the child lock. Refer to "Child Lock" section in this
manual if applicable.
7. Select a cycle and close the door.
8. Check and turn on water supply.
To adjust the volume or deactivate, refer to "Cycle Completion Sig-
nal" section in this manual.
1. Check the fuse or circuit breaker box and replace the fuse or re-
set the breaker if necessary.
2. Ensure that door is properly latched and completely closed.
1. Before starting a cycle, run hot water faucet at the sink nearest
to the dishwasher.
2. Sensors in the dishwasher automatically increase the cycle time
to ensure a good wash when heavy soil is detected.
3. Add rinse agent.
4. Verify dishwasher is connected to hot water supply plumbing.
1. Ensure that spray arm movement is not blocked by hand rotating
spray arms.
2. Remove the spray arms and clean according to "Check/Clean
the Spray Arm Nozzles" in Care and Maintenance section of this
manual.
3. Increase or decrease detergent depending on the water hard-
ness. Refer to Table under "Adding Detergent and Rinse Agent".
4. Clean the filter. Refer to "Check/Clean the Filter System" under
Care and Maintenance section of this manual.
5. Rearrange load such that water spray can reach all items in the
dishwasher. See also "Preparing and Loading" section of this
manual.
6. Refer to "Wash Cycle" section in Operating the Dishwasher sec-
tion of this manual.
1. Add rinse agent. The use of rinse agent improves drying.
2. Rearrange load to ensure items are not nested. Refer also to the
"Preparing and Loading" section of this manual.
3. Rinse and Hold setting does not include drying cycle,
Note: Select models offer an extra heating options to improve drying
performance. Refer to "Wash Cycle options" under the Operating
the Dishwasher section of this manual.
1. Remove the filters and clean according to the "Check/Clean the
Filter System" section of this manual.
2. Refer to "Clean the Door Gasket and Door Seal" in the Care and
Maintenance section of this manual .
3. Run a Rinse/Hold cycle if you do not intend to immediately wash
the dishes.
4. Ensure the unit has completely drained from the last cycle. Refer
to the "Canceling or changing the cycle" section of this manual.
5. Remove any obstructions from the drain hose by calling qualified
personnel.
Note: If odor still persists, run the Normal/Regular cycle until it flushes
and interrupt the cycle and place an 8 oz. cup of distilled white vinegar
solution on the top rack and then finish the cycle.
20