IBM x3455 - System - 7984 User Manual page 66

2. Position the internal cables so that they do not interfere with the cover
3. Reinstall the cover on the server.
4. Install the server in the rack. For details, see the Rack Installation Instructions
5. To attach peripheral devices and connect the power cord, continue with
52
System x3455 Types 7984 and 7986: User's Guide
installation.
a. Position the cover on top of the server.
b. Align the tabs on the sides of the cover with the matching slots on the sides
of the chassis; then, slide the tabs into the slots.
Important: Before you slide the cover forward, make sure that all the tabs
on the cover engage the chassis correctly. If all the tabs do not
engage the chassis correctly, it will be very difficult to remove
the cover later.
c. Slide the cover toward the front of the server.
d. Secure the cover to the server by tightening the captive screw on the back
of the cover.
that come with the server.
Note: Depending on the optional devices that you installed, after you cable the
server, you might have to run the Configuration/Setup Utility program to
update the server configuration. For more information, see "Updating the
server configuration" on page 55 and Chapter 3, "Configuring the server,"
on page 57.
"Connecting the cables" on page 53.
Captive screw