IBM x3455 - System - 7984 User Manual page 52

10. Remove the four hard disk drive mounting screws from the sides of the drive
11. Touch the static-protective package that contains the replacement drive to any
12. Mount the drive in the front hard disk drive cage, using the four mounting
13. Connect the signal and power cables to the rear of the drive. The signal cable
14. Insert the drive-cage assembly into the server; then, slide the drive-cage
15. Close the drive-cage assembly retention latch.
16. Reinstall the CD or DVD drive in the server (see "Installing a CD or DVD drive"
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 51.
38
System x3455 Types 7984 and 7986: User's Guide
5. Disconnect the power and signal cables from the CD or DVD drive backplane.
6. Open the drive-cage assembly retention latch; then, release the drive-cage
assembly by sliding it slightly toward the rear of the server.
7. Disconnect the power and signal cables from the hard disk drive. Note the
cable locations for later use when you install the replacement hard disk drive.
8. Lift the drive-cage assembly out of the server.
9. Place the drive-cage assembly on a flat, static-protective surface.
cage and slide the drive out of the cage.
unpainted metal surface on the outside of the server; then, remove the drive
from the package.
screws that come with the drive kit option.
for the drive in the front hard disk drive cage is labeled "HDD1". Keep the
cables clear of the airflow paths of the fans and air baffles.
assembly forward until it seats securely.
on page 39).
Retention latch
Hard disk drive
tray assembly