Table of Contents
Advertisement
Closing the blade server cover
Important: The blade server cannot be inserted into the BladeCenter unit until the
cover is installed and closed. Do not attempt to override this protection.
Cover pins
Figure 26. Closing the blade server cover
Complete the following steps to close the blade server cover:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. If you removed the front bezel assembly, replace it now. See "Installing the front
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear
4. Carefully close the cover as shown in Figure 26 until it clicks into place.
Input/output connectors and devices
The BladeCenter unit contains the input/output connectors that are available to the
blade server. See the documentation that comes with the BladeCenter unit for
information about the input/output connectors.
36
QS21 Installation and User's Guide
Cover release
on page 19.
bezel assembly" on page 34 for instructions, and Figure 26.
of the blade server, as shown Figure 26. Before closing the cover, make sure
that all components are installed and seated correctly and that you have not left
loose tools or parts inside the blade server.
Cover release
Advertisement
Table of Contents
